One of the essential parts of a work is the hydraulic installation, responsible for the water supply to the residence. Our website have separated some tips for you not to make any mistakes in this stage of construction and avoid future problems.
1 – The Hydraulic Installation Starts With The Water Tank
That’s right, the installation of the water tank is the first step in a hydraulic project. The box must be installed at the house’s highest point to avoid problems with low pressure in the rooms. If the project’s architecture does not allow installation at the highest point, pay attention to the minimum distance between the water tank and the shower, which must be greater than 1.02 m. This distance will ensure sufficient pressure and proper system operation.
2 – Install A Log For Each Room That Has Water
In each room where there are water points, such as the kitchen, bathroom, and service area, install a specific valve. So, if a problem occurs and you need to close one of the valves, the house will not be entire without a water supply.
3 – Make Sure That The Installed Pressure Is Equal To The Projected
For this, you should check the following points in the installation, comparing with what was described in the project:
– the capacity in liters of the water tank;
– the dimensioning of the tank outlet gauge for the main plumbing supplying the building;
– the sizing of the branches.
If, even so, you have any doubts about the pressure obtained at the point of consumption, the ideal is to measure it with a device called a manometer.
4 – Check The Quality Of The Professional Hired
It is essential to have qualified professionals at any stage of a project, and this would be no different in hydraulic installation. The person responsible for the work must have the proper knowledge not to arise during or after installation. So, stay tuned, look for references from professionals and follow your project closely.
5 – Use Quality Materials
Finally, the most important tip: use quality materials in your hydraulic installation. The company carries out a series of quality tests and external audits to ensure the certification of its products. To find out more about our products for hydraulic installations call today.